**  Download procedure Using RXTX.EXE
      
1. Copy the DPSCP.H to the folder in which RXTX.exe is.
2. Connect the SCP card and PC with RS-232C cable and configure the com port (baud rate:19.2K)

3. Move into the ASCII mode. (F1)
4. After pressing the reset button, press the 'enter' key several times within 1~2 second.
5. Input the password 'dcsplussamsung'(small letter)
6. If you see 'scp_boot>', enter the 'LO'
7. Enter 'Esc' key and then you will see the menu.
   Select 'Send file' and then input file name(DPSCP.H).
   
8. Check the LED of SCP card whether it works well or not.
   After a long while, you can see the menu and then select the 'ASCII mode'
9. You can find some kind of information(checksum...).
   To change program, input 'RP'.
10. Flash change LED works again and at the end, you can find the restart message.
    then you may input 'GO' or press the reset button to restart the card.


** Example) Download using TERA TERM

1. Execute TERA TERM.
2. Connect the SCP card and PC with RS-232C cable and configure the com port (baud rate:19.2K)

3. Move into the ASCII mode. (F1)
4. After pressing the reset button, press the 'enter' key several times within 1~2 second.
5. Input the password 'dcsplussamsung'(small letter)
6. If you see 'scp_boot>', enter the 'LO'
7. Enter 'Esc' key and then you will see the menu.
   Select 'Send file' and then input file name(DPSME.H).
   
8. Check the LED of SCP card whether it works well or not.
   After a long while, you can see the menu and then select the 'ASCII mode'
9. You can find some kind of information(checksum...).
   To change program, input 'RP'.
10. Flash change LED works again and at the end, you can find the restart message.
    then you may input 'GO' or press the reset button to restart the card.

If you use other SIO program, execute the same thing which act as 'send file' of rxtx.
Regarding the remainder, the procedure is same with rxtx.